2 Pleated Panels G4 (EU4)
The increased area of this mesh - backed pleat results in low resistance and long filter life at high air velocities.
 

3 Pad & Frame Filters G2-4 (EU2-4)
Alternative to panels where frequent changing of media is required or in damp conditions. Easy changing of pads. Results in reduced filter costs.

5 Fan Coil Filters G2-3 (EU2-3)
Wire framed synthetic, polyfoam cleanable, or pad and frame type.

8 Semi Absolute Filters F6-H10 (EU7-8)
Medium to high grade pleated paper filters of rigid construction with galvanised cases, header frames optional. For general and high specification systems. Always use in conjunction with pre-filter.

9 Extended Surface Filters F6-H10 (EU7-8)
The very high surface area and specification of these filters will give a minimal initial resistance coupled with maximum filter life when used in conjunction with a good quality pre-filter.
 

10 High Efficiency Panel Filters F7-F8 (EU7-8)
High efficiency filters with card or galvanised cases for use in free standing computer room units. Available in a variety of sizes and thicknesses.

12 Grease Filter Housings
Aluminium or stainless steel, designed for easy installation to accept a range of standard grease filters.

13 Carbon Filter Cells
For the removal of odours and fumes, available as traditional housings with replaceable carbon panels, or totally disposable units. Specially impregnated carbons available for Museum or specific fume applications. Use only with pre-filter of EU4 or above.
 

14 Carbon Bag Filters
Used where a more economical alternative to traditional carbon cells is required or where fitting of larger carbon cells is not practical. Available in a variety of sizes and thicknesses.

15 Carbon Pleated Panel Filters
For use instead of or in conjunction with pre-filters, for control of low concentration odours.


 

16 Absolute (H.E.P.A.) Filters H10-H14 (EU10-14)
Traditional absolutes available in timber or galvanised cases with aluminium or Kraft spacers in 4 grades and variety of sizes.

17 High Capacity Absolutes EU10-14
Advanced close pleated media technology enables these filters to be manufactured without separators allowing them to handle a much higher than normal air volume at much lower resistances, leading to a greatly increased filter life.
 

18 Clean Room Filters H13-H14 (EU13-14)
Close pleat type filters available in panel form for use in laminar flow benches and fixed ceiling housings or in hooded form as totally disposable units with integral diffusers and spigots for circular duct connections to fit direct into grid ceilings.

19 Absolute Filter Housings
Available in a range of sizes to suit all Hepa filters as terminal housings, with a variety of casings and diffusers, or for duct mounting with circular spigots as shown.

20 Filter Holding Frames
Front, rear or side withdrawal housings available in any reasonable size, for all types of filter, designed for simple site installation. Also available - 'P' clips and self adhesive neoprene seal for refurbishing existing installations.